How to install the cigarette machine baking igniter


Release time:

2022-08-15

Cigarette machine baking igniter how to buy

Buy cigarette machine baking igniter, generally buy continuous single pulse igniter is more appropriate. In the purchase, we must pay attention to identify the quality. How to distinguish the good and bad quality of the igniter? Here are a few big tricks to teach you:

1, look at the instructions for use, to determine whether it is marked as a continuous discharge type, if the type, confirmed to meet their own needs, you can rest assured to buy.

2. Check the igniter with human eyes to see if the flame produces a line. If it is not a bright line but a single zero line, it means it is pulsed.

3. After replacing the battery, if the white bright line is still not allowed to be generated, it is the bottom line or the dark red line, indicating that the quality is not good.

How to install the cigarette machine baking igniter

Select the igniter and install one in the gas stove, which is very convenient to use. How to install the cigarette machine baking igniter? The following is the specific practice of assembling igniter:

1. Switching power supply: composed of battery and generator. When the switching power supply is in operation, the ignition is given low-voltage electric energy by the battery; after operation, when the generator voltage is higher than the car battery voltage, the ignition system will be automatically given low-voltage electric energy by the generator set.

2. Ignition electromagnetic coil: It can convert the 12V low-voltage electricity provided by the switching power supply into a high-voltage line that can penetrate the gap of the spark plug electrode.

3. Distributor: It can connect and disconnect the primary and secondary current of the ignition solenoid on time, so that the ignition solenoid immediately causes a high-voltage line, and transmits the high-voltage line to the spark plugs of each cylinder according to the ignition sequence; at the same time, it can automatically Adjust the ignition duration with human factors. The function of the capacitor is to reduce the spark of the breaker contact and increase the working voltage of the secondary coil of the ignition solenoid coil.

4. Ignition power switch: control the conduction of the low-voltage circuit of the ignition system, and control the operation and rest of the generator.

5. Automobile spark plug: It introduces the high-voltage line into the combustion chamber of the gas stove, causing spark discharge and then igniting the mixed gas.

6. Additional resistor wiring equipment: When starting, the additional resistor should be wired to expand the initial and intermediate current of the ignition coil and increase the spark kinetic energy of the car spark plug when starting.

FAQ

In daily use, the igniter inevitably has common faults. There are two main types that are more common:

One is that the AN knob switch is prone to failure. This is basically due to the deformation of the spring sheet on the power switch, or the oxidation of rusty air caused by water seepage and stains, and the switch contacts cannot be reliably touched, which may cause the circuit to fail to work normally. For this matter, after opening the shell, the spring sheet in the deformed power switch can be solved by plastic surgery and cleaning and decontamination.

Another common fault with high incidence is that when pressing and holding the AN power switch, although the sound of high voltage discharge can be heard, there is no electric arc (spark discharge) on the top of the front head of the equipment.